Ipad not included, was design for 11" Ipad 10 (2024-2025)

Fits over the keyboard cable and sits the Ipad inbetween the monitor bottom frame (at full reach) and the top of keyboard

Print in elegoo PLA - green standard PLA settings

PLA nozzle 215C,  60C bed Side A, no glue or supports

To assenbly slide the backbrace down of the left and right sides (tight fit slides-in). then place on top of the base and add the 4 loop clips holding the left and right sections to the base. Just add Ipad

Allows for Ipad and cover upto 14mm think