Replacement for the included activated carbon bag from Anycubic – fits perfectly into the existing slot. Simply buy a larger quantity of acid-free activated carbon pellets (e.g., 4 mm) and refill every 2–3 months, depending on printing hours. This solution is not only simple but also significantly more cost-effective in the long run.

The closure slides open and shut easily but remains secure even if the container tips over. The semi-rounded guide rails can only be printed cleanly with my Anycubic Kobra S1 at a layer height of 0.16 mm – this value is stored in the print profile.

Material selection: Pay attention to the material you are printing and how hot the interior gets. If in doubt, a more heat-resistant material like ABS is recommended.