Filament stand
filament accessory
filament holder
Filament stand
Print Profile(1)
- 0.2mm layer, 3 walls, 15% infill
1-disc
ABS
Designer
110
48
Released 2025-08-13
This is a Filament stand so that you can conveniently hold your spools with easier access. It has a strong triangular design with honeycomb pattern in between the triangle.
There is also a small hole in the legs to guide your filament and stop unwinding.
To make sure this stand is right for you spool check these specifications fit:
- Minimum spool inner diameter: 48mm
- Maximum spool outer diameter: 140mm
Recommended Print settings:
- 4 walls
- Gyroid pattern infill at 15%
- Orientation flat on its back for faster printing
- Support on (Tree recommended)
Originality of the Model
The author declares that this work is their personally original model
This model is licensed under the following terms:
Credit must be given to the creator
Only noncommercial uses of the work are permitted
Remixes must be shared under the same license
Models(2)
filament-stand.stlDesigner
2.16 MB
2025-08-10
- Filament stand.3mfDesigner
577.67 KB
2025-08-10
No more
