Warning: Brim and extended Support are a necessity to the success of the print! Also make sure to use glue…a lot of glue, or you'll end with only a couple of detached boots…

It may be necessary to rub the boots sole with sandpaper a bit to smooth them and make the model more stable.

I tried my hand at modelling something more complex that a Pokémon and will probably not try again soon…hate Goku's hair, but I always enjoyed his character in manga and cartoons, so I wanted to make him once at least.

I provided a printing profile with both Mono and Multicolor settings; still didn't try the second, requiring way too much printing time and filament for my taste. May try in the future.

Hope you'll enjoy this model. Let me know if you know any way to print it properly by using less material for the support.