Description:

Made this model for a friend who didn't like the models available for this Pokémon and his Shiny variant.

As the model is quite spicky and the tips can be stinging, I suggest not leaving the model in the end of a young child which could hurt itself whilst playing.

Printing instructions:

This model need a bit of support for back spikes, the inside of the mouth and the upper teeth; I set them properly in the printing profile, so no need to change anything and should work properly as is.

Assembly instructions:

Nothing to assemble as the model is made in one single piece.

Post processing:

*ONE IMPORTANT WARNING*: whilst removing the support on the back, make sure to not keep it in the direction of your face. The spikes could really hurt you and your eyes if you were to accidentaly pull against you whilst trying to remove the support.

Aside from the above warning, the support itself isn't hard to remove with a pincers; just try to be delicate on the back part to not hit and ruin the tip of the spikes, as it happened once with one of my printed models.