A paint brush holder with a snap on handle! (similar to old candle holders). The hollow Cylinder snap-fits into the Bottom part, the Top part then snap-fits into the Cylinder, and the handle snap-fits into the Top part (lots of fun snapping!). Handle snap-fits into any of the 4 sides.

Holder keeps the brushes standing perfectly straight so that the softer bristles aren't damaged.

Fits 24 Brushes (Hole diameters below):
12 holes at 7mm
8 holes at 9.9mm
3 holes at 9mm
1 hole 14.5mm

I printed:

• Bottom Body at 20% infill
• Cylinder at 20-30% infill
• Top Body at 60% infill
• Handle at 80% infill (Only the handle needs support - very little of it)

Top/Bottom/Wall Layer = 3