Elegoo Neptune 3
Elegoo
169
6
Hide the coiled lead. Keeps the lead up off the ground.
I rarely take the console out of its dock. Helps to keep dangly bits to a minimum...
Print at any setting. This one was done roughest setting and a speed of 100mm/ps.
Took just over an hour.
One thing is that unfortunately its quite awkward to get the allen/hex key into the screw point. The hex wrench that came with the printer was not long enough. I used my longer size 2.5mm drivers.
Just unscrew the console holder a few mm. Then fit the part in between. You can see in the images I posted. Then just tighten.
Originality of the Model
The author declares that this work is their personally shared model
This model is licensed under the following terms:
Credit must be given to the creator
Models(2)
elegoo_3_pro_cable_hide.stl
126.55 KB
2025-07-18
- ELEGOO_cable_store_v2.stl
156.43 KB
2025-07-18
