P3steel
improvement
Y Bar Stopper
2
1
The Y bars on my P3Steel XL (from KitPrinter3D) can very easily slide out of their mounts so I needed a way to stop them dropping out but also allow them to be removed easily for maintenance.
The Prusa i3 Steel end Y Axis by weros was a good start, but because of its height above the bar it stopped the print bed from moving to its full Y distance (the clearance between the Y bar and bed mount is just over a 1mm and moves beyond the length of the frame by several cm at the extremes)
Printed this part in ABS and it holds onto the frame well.
Originality of the Model
The author declares that this work is their personally shared model
This model is licensed under the following terms:
Credit must be given to the creator
Models(2)
YBarStopper_P3SteelXL.stl
14.04 KB
2025-07-16
- YBarStopper_P3SteelXL.123dx
58.74 KB
2025-07-16
