Funnel - stand and filter to suit Mono X printer vat and Anycubic resin bottles.
The weir section of the unit contains 3 printed filters ranging from fine to course (if further filtration is required then you can insert filter paper between the printed filters).
The weir section then screws onto the funnel section and onto the bottle.

Place the bottle onto a level surface and pour the left over resin into the funnel. Funnel is purpose built to allow the vat to stand in the funnel (refer to drawing shown the arrangement).

The unit has been designed so that the centre of gravity of the vat is the same as the axis of the bottle (it is balanced so that it does not want to fall over).

Once finish, clean funnel and drop the weir and filters into some iso to clean.

If filters break after extended use - reprint new filters.

UPDATE - added a smaller funnel for smaller bed sizes (100 x 50mm).