holder
kitchen
clip
glass
glass holder
glass panel
Glass panel holder clip for kitchen cabinet/window
Print Profile(1)
- 0.2mm layer, 2 walls, 15% infill
1-disc
PETG
Designer
1
0
Released 2026-06-08
Glass panel holder clip, to replace the old broken clips on our kitchen cabinet door. Recommended to be printed using PETG, but PLA will do the job too.
The ‘tab’ part has a slight angle, so if you screw it in hard, it should press the glass, keeping it tight.
Originality of the Model
The author declares that this work is their personally original model
This model is licensed under the following terms:
Credit must be given to the creator
Only noncommercial uses of the work are permitted
Remixes must be shared under the same license
Models(1)
- konyhaszegreny_uveg_clip.3mfDesigner
64.77 KB
2026-06-04
No more
