Planter Tower - Vase mode spiralize
If you like it --> press like it :-)

I´ve designed a planter for e.g. succulents, sempervivum, maybe strawberries with two top designs (round and swing) and two flat plant coaster.

Additional a variant with some spiral effect and the same with smaller diameter and two flat plant coaster to the small version.

It´s made for vase mode and therefore a good demonstrator, what a 3D printer can do in a short time period.
The Planter Tower from the pictures(planter_round.stl) is printed in PETG with a 1,0mm Nozzle, 0,2mm height for the first layer and then 0,5mm layer height (three bottom layer →1,2mm). You need this 1.2mm height for the drain holes at the bottom.
It took 3h40 (on my CR10-V2 which could only print slow) for the print with 25mm/s and total height of 205mm! The bridges are around 57mm.

Would be happy to see your makes!