An elegant, modern planter with a stylish striped design and practical, curved handles. The perfect eye-catching piece for your windowsill, dining table, or desk!

The design leverages layer height to achieve an exceptionally clean color transition. This means you don’t necessarily need an AMS for this two-tone look—you can easily control the color change by pausing the slicer at the desired print height.

Settings

Recommended Value

Reason

Nozzle

0.4 mm or 0.6 mm

A 0.6 mm nozzle prints faster and naturally produces a denser finish.

Layer Height

0.20 mm – 0.28 mm

The optimal balance between print time and fine surface quality.

Wall Thickness

3–4 walls

Important: Increasing the number of walls ensures the pot is completely waterproof.

Infill

10%–15% (gyroid pattern)

Required only for the base and handles.

Bottom Layers

4–5 layers

Provides a dense, stable foundation.

Filament

PLA or PETG

Matte filaments (like those shown in the photo) look especially refined here.

💡 Tip for absolute water resistance: Print the filament approximately 5–10 °C hotter than usual, or increase the flow rate for the inner walls to 103%–105%. This ensures perfect fusion between layers, preventing any water seepage.