Description

This is a backplate based off of the original Ender 3 backplate. This does NOT include all the original holes and spots for screws, just the ones for the hotend and shroud as those are the only ones needed as far as I know. The screw holes may be too tight or too loose, if so please tell me, but I did make them to fit well. PLA, PETG, ABS, and others, excluding TPU and other filaments like it, should work fine, just in case you have bad airflow or the heatsink part of the hotend ends up heating up more than it should it may cause the backplate to melt at the points where the hot end touches, it should work fine if you use ABS to print it though.

Description

I am fine with you using it on your printer, just if it is in a YouTube video or something similar, or if you are selling it or posting it somewhere where it is one of the main things, I would like for you to add a link to this page. for any questions, please ask me in the comments.