20 cm Plant Saucer / Drip Tray for Outdoor Use

Does your hardware store get crumbly? Not this one. A sturdy drip tray with 4 support pads for clean drainage.

You know the feeling: it rains hard once—and afterward, your pot ends up sitting in a pool of water 😁

That’s exactly what this plant saucer/drip tray is designed for: inner diameter 200 mm, height 20 mm—perfect for larger outdoor pots.

The special feature: Inside, there are 4 wide support pads. This keeps the pot slightly elevated, allowing excess water to drain cleanly or spread out instead of leaving the bottom permanently submerged (many pots have a slightly “deeper” base).

Material note for outdoor use:

I print it in PETG (weather-resistant and tough). If your saucer will regularly sit in full sun, then ASA is an even more robust choice.

Enjoy printing—and if this model helps you, a like, comment, or make would mean a lot and assist others in their selection. 😉

Printing settings (recommended)

• Orientations: as shown in the model—flat on the build platform

• Wall lines: 3–4 (for heavier pots, prefer 4)

• Infill: 20% Gyroid

• Top/Bottom: 4–5 layers

• Support: none required

• Material: PETG recommended, ASA for intense sun/heat

• (Optional for ASA): brim to prevent warping