🔧 Rear Ramp + Magnetic Purge Bin for the Elegoo Centauri Carbon 1 equipped with CANVAS 🔧

After installing the CANVAS on my Centauri Carbon 1, the spool positioned at the lower rear of the machine ended up blocking the use of my previous purge collection bin and the ramp I had originally designed.

So, I went back to the drawing board and created a new rear-offset ramp along with an adapted purge bin, making the system practical again without interference from either the spool or the CANVAS cable.

✅ Offset design to avoid interference with the spool
✅ Compatible with CANVAS cable routing
✅ Magnetic system for quick placement, even without direct visibility
✅ More accessible handle thanks to the shifted position
✅ Parts designed for easy printing with no supports required
✅ Requires 6 magnets (8×2 mm) for the magnetic attachment system (https://s.click.aliexpress.com/e/_c3UQlCLX) 

💡 I recommend printing both the ramp and the purge bin in PETG to avoid hot PLA purges sticking or causing deformation over time.

A small upgrade designed to make daily use of the CANVAS setup much more practical 😊