Design Concept

The spacers are designed for the Creality K2 Series to help improve cable management and reduce wear through the use of a drag chain. Over the time of the printers usage the drag chain of the cable may begin to sag, which the causes rubbing on the print head cover as can be seen in the photos, this can also introduce more wear and cause the chain to sag furter. This simple print attempts to circumvent this to prolong your printers usability. 

Use 

The spacers are provided in different thickneses depending on the need and the amount of sagging, in my case I was able to just use the 0.8mm spacer which was enough. Multiple spacers provided in +0.8mm increments of thickness.

Printing Suggestions 

Should be printed in ABS/ASA or at minimu PETG due to being inside of and near hot surfaces/areas.