These dividers allow you to subdivide your multigrid bins and maintain compatibility with other inserts. 

You can just click one into a bin, it will stay vertical and will be able to move along the bin, this may be all you need. If you don't want it to move read on…
 

Positioning the divider

The divider's have a set of holes in the ends which Divider Clips can be placed into (and easily removed).
 

The positions of these depend on where along the bin you want to place the divider:

The green vertical locations use the tall holes and the red and blue positions use the wide holes.

Note you actually only need one clip per end and I recommend using the bottom location. The only exception to this would be if you use divider that is not as tall as the bin, then you can't use the bottom blue clip as it will not reach the indent in the bin so you would need to use the top red location instead.
 

Subdivision

Since the dividers contain indents themselves they keep compatibility with other inserts, like themselves and therefore let you subdivide further:

They are designed so that the subdivided space remains dimensionally the same as a bin of that size.

I hope you find them useful :-)

Printing

When printing I use a 0.2mm layer height, 3 walls and a 5% infill just so that there is occasional inter wall support, if you think about the bins they do not have support along their walls.

Rate?

Please consider rating my print profiles, they take significant time to create and test. For those interested here are is a picture of some of the earlier designs: