✨IF YOU LIKE MY MODELS FOLLOW ME AND SHARE✨

Project: luffy.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.24mm

Filaments Used:
    PLA Black Transmission Distance: 0.3
    PLA Red Transmission Distance: 4
    PLA Yellow Transmission Distance: 6
    PLA White Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer #10 (0.96mm) swap to Red
    At layer #18 (1.6mm) swap to Yellow
    At layer #21 (1.84mm) swap to White for the rest.
 

Note: for your Perphet alignment with other images in honeycomb mode download the guide

https://www.nexprint.com/en/models/ G0471687?printConfigId = G0369851

Every impulse helps me to continue creating new designs. I appreciate your support so much!

Don't forget to like it and save it so you can find it easily later!