Description:

A simple decorative dragon ring.

I've uploaded a print profile for a ring with an internal diameter of approximately 22mm; the model can be scaled down or up to fit your fingers. If you're unable to get it to fit properly, please let me know and I'll upload a print profile for the desired size.

Printing Instructions:

The support is already set to meet the model's needs.

Assembly Instructions:

No assembly required, as the model is cast in one piece.

Post-processing:

I recommend using fine-tipped tweezers to remove the support, being careful not to break the dragon's teeth. After removing the support, you may need to sand the inside of the ring to remove any debris left by the supports, smoothing the surface and avoiding irritation.