Firewood (Leña) is a fully 3D printable table lamp design.

Its design was inspired by a curious curved geometry that as it grows has distorted forming a trunk that will set the mood in your home as if it were a log fire.

Its assembly is simple and intuitive. After printing the two pieces and buying the cable and socket for the bulb just pass the bulb cable through the hole in the base, screw the disc or stopper to the socket, screw the bulb and finally place the body of the lamp coinciding with the slot in the base.

Here is the link to the cable and socket I bought: amzn.to/450MBgY

For the bulb any E27 model would do, being able to play with the intensity or warmth of the light.

3D printing settings

The printing of each of the two parts is done with a recommended layer height of 0.2 mm although a higher layer height could be used for the printing of the body.

The body (firewood.stl) should be printed with clear plastic (I used 3DJake brand clear PLA) or you could even use white if the bulb is very bright. This is a solid model and you have two options for printing it, both with 0% infill, wall line count: 3 and top layers: 0 and no supports:

• Bottom laters: 0 so that the end lamp is open at the top.

• Bottom layers: 5 so that the end lamp is covered at the top.

For the base (baseleña.stl) it should be printed in the reverse orientation (legs up) and using support for the slot. For this piece I used a 20% infill and a green matte PLA but you can use any color you like.