Stealth 4 Cover

Functional snapfit enclosure for your crono

Printing recommendations & Assembly

To print this model you should consider if you use it very often or in extreme weather condition so you may want to consider a strong filament like PETG, ABS or ASA otherwise if you use it only rarely you can go straight with PLA.

The enclosure is made of two part:

• The Top: the cover for the upper face
• The Bottom: the GPS envelope 

The assembly is super fast and easy:

• Insert two M6 or similar countersunk screw
• Put your device inside the casing
• Drive the wires outside the cover
• Close everything with a click

📸Images shown are from a print of a prototype(now has better finish and details) made of eSUN white e-PLA lite.

For any question or suggestions feel free to leave a comment or send me an e-mail at:📧 [email protected]