This is a 3 part print that consist of the Cauldron Base, Mid-Plate, and Top Bubble Plate.  These parts will allow you to have a decorative humidifier by adding ultrasonic humidifier to the prints.

Check out our video to see the assembly.  Inside the cauldron base you will need to add water. We made the cauldron large enough to hold a small jar for the water if you prefer. Once the water is added, you will want to put the mid plate in the center of the cauldron. The Filter for the ultrasonic humidifier will fit through the hole in the mid-plate and hold the top of the ultrasonic part upright. You will want to put the wires through the hole in the cauldron. Below this area and on the outside of the cauldron, there is a place to slide the circuit board in. The wires from the ultrasonic part needs to be plugged into the board. The Board then needs to have the usb cord plugged in. Place the bubble top plate on the cauldron.  On the Board is a button to start the humidifier going.

To get the Ultrasonic Humidifier parts please visit https://amzn.to/4o5zeF3

*Please note that if you decide not to use a jar for the water, please make sure you use the correct materials for printing a water tight model.