Charging phone holder on socket with large button - Skratt

Charging phone holder on socket with large button

Skratt

Print Profile(1)

Elegoo Centauri Carbon, PLA, 0.4 nozzle, 0.2mm layer, 2 walls, 15% infill

1-disc

PLA

Designer

Released 2025-10-10

I quite liked the simple & efficient design of 3DLUCA Phone Holder for Charging - 2 in 1.

But after printing it, I realized that all my sockets had buttons in them … and that I could not use my newly printed phone holder.

I then designed this charging phone holder which works with our sockets with button.

After charging the phone, the phone holder can be used to hold the charging cable.

Button is 23.8x38.6 mm and is located 2 mm higher than the power socket.

Phone width: 11.8 mm

☕ Enjoying the design?

If you found this design helpful and would like to support my work, feel free to buy me a coffee!

Offer me a coffe, and I will gladly adapt the model to your specific needs.

Originality of the Model

The author declares that this work is their personally remixed model

Original creator:

3DLUCA

This model is licensed under the following terms:

Credit must be given to the creator

Only noncommercial uses of the work are permitted

No more