Adding the Star Destroyer to the Star Wars HueForge Hybrid collection! This was requested a fair bit and I finally found time to sort it out. 

This is another print in place model, no glue or assembly required post print. 

NOTE: The overhangs on the left side of the destroyer may require cleanup post print depending on your printer/filament's ability to pull off the overhangs. I had to run a heat gun for like 5 seconds over the edge to get rid of some wisps but other than that, it printed fine! 

The 3MF file should already have the necessary filament swaps entered in for you, but here are the instructions if you want to use your own settings. I have uploaded 2 versions, one that will fit the X and P printers, and another that will print on the H2D on both nozzles. 

Print Instructions

For the HueForge portion (0.00m - 1.96mm)

• Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mm

For the Star Destroyer portion (1.96mm onwards)

• 0.16mm layer height
• 3 walls, 3 tops, 3 bottoms
• 8% CrossHatch infill
• Slow down for overhangs (I use 10mm/s for 100% overhang walls)

Filaments Used:
- #000000 PLA BambuLab Matte Charcoal  Transmission Distance: 0.6
- #55007f PLA Phaser3D Purple Sparkle  Transmission Distance: 2

- #00358e PLA Flashforge Burnt Titanium Transmission Distance: 4
- #87858c PLA Kingroon Grey  Transmission Distance: 2.5
- #21bcff PLA TECOR Light Blue  Transmission Distance: 3.5
- #ffffff PLA Kingroon White  Transmission Distance: 5.8

This print uses 6 unique filaments

Swap Instructions:
- Start with Charcoal
- At 0.68mm swap to Purple Sparkle
- At 0.84mm swap to Burnt Titanium
- At 1.16mm swap to Grey
- At 1.4mm swap to Light Blue
- At 1.56mm swap to White

- At 1.96mm swap to Grey
 

The full Star Destroyer model can be found here by Mat3D. It's a beautifully detailed model, and if you want to print it standalone, I highly suggest downloading it for yourself!

If you like my work and would like to support me, you can now subscribe to a Thangs membership plan!, or if you prefer, my Patreon.

Joining will give you access to a private discord, all paid models, early access to some models as well as a commercial license to sell the physical prints of my models.