This a bike mounted Phone holder for daily use. The design utilizes 2 compliant mechanisms, 1 for the main grip and the other for the holder. There are 3 sizes of holders, for larger phones/ cases. a 6.1-inch screen like the 15 pro with a thin case can fit in a small, whereas a 16 pro max with a 6.9-inch screen would need the large, and anything in-between for medium. I do recommend measuring your phone with the case on first. The angle adjuster uses a toothed pivot mechanism, so that you can adjust the angle but not worry about it going limp during your ride. For this reason, a recommend printing the toothed parts in a layer height no higher than .15 mm. I used PETG for the whole thing, because of its strength, and as it's less brittle than PLA. Using PLA will result in creep and may break the phone holder part.

You'll need two small screws, (3 if you want it really tight) and nuts to match. 3 M3 40 screws and nuts should work, but I was out at the time, so I used others. I put some electrical tape on the part of the grip making contact with the handlebars, as to provide extra stability. This part is crucial, as the handle bars are round and the holder may slip if not tight enough. You'll also need to glue the connector, holder, and other gear together in the right orientation.

Print settings:

PETG

3 walls

15% gyroid infill

0.15mm layer height