I wasn't too happy with the fitment of some other risers I've tried. So I made my own.

I had the following goals with this build:

• Precisely fit exactly in the existing lid slot
• Raise clearance, not lower
• Allow the lid to easily slide back when I want partial venting
• Fit 8mm or 10mm LED strips
  • Most 8mm solder-less connectors are about 10mm wide

The two rear supports are designed to be glued on, and will provide a further sliding range for the lid.

I've made sure to include the original FreeCAD file if you:

• Want a taller raise / larger LED strip support
• Want to print the rear supports connected to the rear legs
  • This will take quite a bit more support material
• have a printer large enough to print as a single piece.