Description:

A picture of Itachi Uchiha created using Hueforge software, at the request of a friend who is a fan of the character.

Printing Instructions:

No support (although Bambu Studio can advise if one is needed) or brim is required. If the print profile is not set correctly or you prefer to set it manually, below are the instructions provided by the Hueforge software:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mm

The Model is 137.79x200mm in size 
You may print at higher layer heights below the Min Depth of 0.52mm 
The Max Depth is 2.3mm and the Actual Depth is 2.2mm

Filaments Used: 
PLA BambuLab Basic Black Transmission Distance: 0.6 
PLA BambuLab Basic Red Transmission Distance: 4 
PLA BambuLab Basic Orange Transmission Distance: 7 
PLA BambuLab Basic Yellow Transmission Distance: 6 
PLA BambuLab Basic Jade White Transmission Distance: 5 
This print uses 5 unique filaments

Swap Instructions: 
Start with Black
At layer #7 (0.68mm) swap to Red
At layer #13 (1.16mm) swap to Orange
At layer #15 (1.32mm) swap to Yellow
At layer #16 (1.4mm) swap to Jade White for the rest.

Assembly Instructions:

No assembly required as the model is made in one piece.

Post-processing:

Some stringing may appear on the surface; a quick blow-dry with a hairdryer or lighter should remove it.