A very simple mini of Darth Vader. It buggs me that a lot of the minis out there dont make the iconic and fashionable skirt Darth Vader wears! It has the chest and belt prepared for multicolor printing, however due to the size, a 0.2 nozzle is recommended to print the chest pieces.


 I hand painted his chest buttons and the option for that is enabled in the profile, however if you want to use the AMS, you need to enable the object.

Also I would like to point out that the head and body are printed separately, the body is tricky to print due to the angle. If you have a bed slinger I suggest you put the printer on silent mode to have a 99.99% success rate. 

Since posting this, I did some polishing of the model, cut a millimeter off the head so there are minimal supports and added a hole so you can use magnets to connect the head to the torso (there is an optional pin you need to enable if you do not want to use magnets). 

You will require 6 standard 3x2mm magnets, I did it like that so it has more holding power. 

If you do not have any, there is a pin you can use that will work very well.