EDIT I added a file to mount to the right side if you are looking at it from the outside. I also slimmed and smoothed it out some.

I made this mount with the intention of going to FULL Bowden on the Little Monster. I think its one of the best additions I have made to the printer.

This should just need minimal clean up with a hobby knife clean up. The mounting holes were made for M4 to use with T-nuts on 20x20 style extrusions.

I have mine mounted on the X (Alpha) tower with the screw/knob facing the tower. it works well for faster filament changes. You will need to up your retraction a lot. I recommend starting at 7mm and going from there.

UPDATE 6-18-17: I modified the current mount to allow more room for the thumb wheel for those that have the real E3D Titan. I also found that the spacer makes it too thick, and the stepper shaft can't reach the stabilizing hole in the Titan cover. so I narrowed the center section on the update.

I added a Vers.6 for better thumbscrew clearance.