8
3
There can never be to many Buddha remixes!
Models:
Creepy_Baby_Buddha_01
Is the original remix. The mesh has a number imperfections and my be difficult to slice with some slicers. Works fine with Cura.
Creepy_Baby_Buddha_02
Has bean cleaned up using Meshmixer so it should now work with less forgiving slicers liks Simplify3D. However, this process inevitably results in a slight loss of fine detail, therefor I would recommend attempting to slice 01 version first and only if it fails use the 02 version.
PRINTING DIRECTIONS:
I haven't printed it myself yet but as with "Creepy Baby Bust" i would suggest that rather than printing the model in its upright position, tilted it backward 40-45 degrees so as to get the best results around the face by reducing the overhang on the chin, brow etc. Doing so will require more support structures though.
Originality of the Model
The author declares that this work is their personally shared model
This model is licensed under the following terms:
Credit must be given to the creator
Models(2)
Creepy_Baby_Buddha_01.STL
6.09 MB
2025-07-14
- Creepy_Baby_Buddha_02.STL
4.62 MB
2025-07-14
