fearthewalkingdead
lithophane
TWD
thewalkingdead
ftwd
Nick Clark Fear The Walking Dead lithopane
Print Profile(0)
21
3
Released 2025-07-17
Print this Vertical
Layer height: When printing vertically, it’s best to set the layer height as low as possible (0.16 mm).
Print speed: Try to keep it lower than 45 mm/s.
Infill: Setting the infill to 100% will let the light work its magic better.
Originality of the Model
The author declares that this work is their personally shared model
Original creator:
thriddimensionprints
Reprint source:https://www.thingiverse.com/thing:6106668
This model is licensed under the following terms:
Credit must be given to the creator
Models(1)
nickclarklithophane.stl
10.29 MB
2025-06-30
No more
