This alternate group consists of 5 main pieces and one optional piece, which are intended to overcome the following original issues present in the lid of the K1 and K1C models of the Creality brand:

• Undesirable lateral impacts of the chain belt and PTFE tube against the cover: Efficient increase in left side cover by 2";
• Excessive throttling in the PTFE tube due to the tight radius at the minimum stroke X and Z: Lifting the lid 3" more;
• Maintain low vibration by using four lower magnets (10 mm diam rings), 2 or 4 M3 allen screws on top
• Do you need to remove the cover to ventilate the chamber when printing with PLA?: Don't remove it, just rotate it 45°, it looks fine and maintains soundproofing.
• In total you will need a maximum of 7 wood screws #6x1/2" or similar, or if you prefer you can also use zip ties.
  *I have left some customization available for your own whim, should you not opt for using zip ties, I have included my suggestion of the Sheikah symbol, from the video game The Legend of Zelda

Note: I also chose to include an improvised ramp film/sheet to help with chain entry on the left extra cover.