Summary

Articulated Oriental Lung Dragon

This is my Tenth dragon project and brother to Sea Serpent as Most of structure is smilar as it. i was unsure i have to add some accessary as cloud shaped part at Forearm Port and Back leg Port but i didn't have any idea for them. same as Tail Tips which supposed to insert some thin layer part between them.

I was unable to finish Test print this project before leave place for works for undefinitely, i hope you can finish this while i couldn't.

Open Source : My last present for ya, Feel free edit remix and fix, sell your make whatever you want. Just make sure share photo of your makes please!

Thank you All

hopefuly see you later with another project... hopefully... in another few years...

Print Settings

• Resolution: 

             0.15~0.2

• Infill:

  10

• Filament brand:

  Any

• Filament color:

  Any

• Filament material:

  PLA / ABS

• Notes:

  Before try build this dragon

  This is 2~3+ weeks long project with large consume of material and times

  for example, each 5 piece of segement will take 5~7 hour. and Sepentine body alone at least 60 segments, and even more if you decide extend even futher with extenderble segements. and it difficult to scale down with Claws as some said claw parts are already minimum size with almost no room for scale down.

  it will be better to understand build and structure if you had built one of my dragon especially Sea Serpent before try this dragon.

  it will even better if you can use 3ds Max to adjust Ball and sokets itselfs.

  Part Aligns

  Most parts 45' angled orientation is intended on purpose to protect fragile skirt scales and the Ball from heavy stress presure. please do not request to change it

  Head

  Head
  Head Jaw
  Head Tung

  Eyes

  Head Horn 0.1mm Layer
  Head Feeler 0.1mm Layer

  Heat to Neck Pin

  ***+ Scales is Added scales from previous parts in desgin , you don’t need to add this Scales in instruction.

  Body

  01~05 +102% scale

  06~10 +103% scale

  11~15 +104% scale

  16 Cupled with 17 Fore leg port
  17 Fore leg port

  18 Extenderble Segments
  This segements are suposed to attach over again before attach 19 to make rest of body.
  recomended make 6~8 segments

  19 cupled with 20 Back leg port
  20 Back Legs port

  21~ +97% scale

  Tail Tips

  Fore Legs and Back legs

  Fore Arm Sholder X2 (Symmetry)
  Fore Arm Upper X2 (Symmetry)
  Fore Arm Lower X2 (Symmetry)
  Fore Arm Foot Hub X2 (Symmetry)
  Claws finger X8
  Assemble Fore Arm Foot and claws are a bit difficult as it thight to insert parts

  Back Leg Upper X2 Mirror
  Back Leg Middle X2 (Symmetry)
  Back Leg lower X2 (Symmetry)
  Back Leg Foot X2 (Symmetry)