Description

NEW! PORSCHE 992 GT3 RS AVAILABLE: https://makerworld.com/en/models/1020759#profileId-1002049

PORSCHE 991.2 GT2 RS AVAILABLE: https://makerworld.com/en/models/983297#profileId-957370

IMPORTANT: Since the launch of this model I´ve implemented a “Boost Method” where each user that boosted this model 6 or 8 times would get a 911 GT3 RS 992 or 911 GT2 RS 991. But MakerWorld only allows to Boost one model 2 times per user. Didn´t know this until lot´s of you dm me to tell me about this. So as suggested by some users, I´ll keep using boosting method but in a Communitary way instead of an Boost per user way. So after this model reaches Boosts count I´ll upload to MakerWorld both showed Porsches. Thanks everyone for boosting :)

NEW OPTIMIZED 0.4 Nozzle and NEW Split in half print profile for 0.4 Nozzle.

Porsche 911 GT3 RS. The highest quaility Porsche 911 models in MakerWorld are here. And now with Infill and Split in Half print profiles.

3 Print profiles added 3 for 0.4mm Nozzle (Full Body, Rims and Split in Half Body) and another 2 for 0.2 Nozzle (Full Body and Rims) this last one reccomended for high quality.

IMPORTANT: Showcased images are from 0.2 Nozzle print profile (Green GT3 RS) and from 0.4 Nozzle print profile (Bright Yellow GT3RS) Remember if you want the best quality for this model as you can see in photos, use 0.2 Nozzle.

Remember this is a High time Expensive, Ultra High Quality 3D Print, so expect long printing times and lots of very careful support removal specially with the spoiler.

Enjoy :)

Any problem you find while slicing, printing or other problems, let me know in comments. Thanks :)