This 3D-printed photo stand is designed to display photos, postcards, or small prints using a clean and minimal structure.
The model supports two different configurations, depending on how many vertical supports you want to use.

Design Variants

• Single-support configuration
  Uses one long vertical support placed in the center of the base. Ideal for individual photos or a minimalist look.
• Double-support configuration
  Uses two vertical supports placed at each end of the base. This setup provides extra stability and is suitable for wider or heavier prints.

Both configurations use the same base concept and allow the photo to slide easily into place while remaining upright and stable.

Recommended Use

• Place one or two vertical supports into the base slots
• Insert the photo or card between the supports
• Display on a desk, shelf, or tabletop

Printing Notes

• No supports required
• Print with PLA, PETG, or similar materials
• Print flat on the build plate for best stability and surface quality

A simple and elegant solution for displaying photos or cards, with flexibility to choose between a single or double support layout.