3.5in Slot cover
Print Profile(0)
4
1
Released 2026-04-12
This is a cover for 3 ½ in slots on PC cases (eg floppy drives)
printing them in PLA worked fine for me and the tolerances where tight enough for me for them to fit in snug
print with the retainment prong side up to save on supports
depending on your print bed you may want to print on tape if your bed tends to leave permanent visible residue
Originality of the Model
The author declares that this work is their personally original model
This model is licensed under the following terms:
Credit must be given to the creator
Only noncommercial uses of the work are permitted
Remixes must be shared under the same license
Models(1)
3.5in Blende.stlDesigner
11.44 KB
2026-04-10
No more
