CFS Front Desiccant Box
Print Profile(1)
- 0.2mm layer, 2 walls, 15% infill
1-disc
PETG
Designer
45
4
Released 2025-10-14
Silica gel desiccant containers for in the front of a CFS. Fits seamlessly at the front of your CFS.
- Hold about a total of 120 grams of desiccant
- Print in two parts for easier management and able to print on smaller print beds
- Top lids slides on and off for easy filling
- Prints without supports
- Width of the slots are 1.8mm so use silica beads > 2mm
- You may want to add some double sided tape to the bottom to prevent you from knocking them over when changing filament
Originality of the Model
The author declares that this work is their personally original model
This model is licensed under the following terms:
Credit must be given to the creator
Only noncommercial uses of the work are permitted
Remixes must be shared under the same license
Models(9)
- CFS_Front_Desiccant_Box.3mfDesigner
277.48 KB
2025-10-12
CFS_Front_Desiccant_Box-Box.stepDesigner675.28 KB
2025-10-12
- CFS_Front_Desiccant_Box-Box.stlDesigner
2.95 MB
2025-10-12
- CFS_Front_Desiccant_Box-LidCenter.stepDesigner
112.01 KB
2025-10-12
- CFS_Front_Desiccant_Box-LidCenter.stlDesigner
435.24 KB
2025-10-12
- CFS_Front_Desiccant_Box-LidLeft.stepDesigner
58.87 KB
2025-10-12
- CFS_Front_Desiccant_Box-LidLeft.stlDesigner
203.99 KB
2025-10-12
- CFS_Front_Desiccant_Box-LidRight.stepDesigner
59.14 KB
2025-10-12
- CFS_Front_Desiccant_Box-LidRight.stlDesigner
203.99 KB
2025-10-12
View all(9)
No comments yet
