Cute Owl Key Holder

Features:

Owls fit into cut silhouettes. It is possible to adjust the height of the base (increase the distance from the wall). In the print profile, all parts are 7 mm. Model's final orientation is different to placement on bed (is mirrored to give the a better surface => face down for PEI plates). 

Print settings:

1st bed - Owls / keychains.

0.4 nozzle / 0.2 layer / 3 walls / 15% infill

I highly recommend brim!

2nd bed - Cover part

0.4 nozzle / 0.24 layer / 2 walls / 15% infill

3rd bed - Base part

0.4 nozzle / 0.24 layer / 2 walls / 15% infill

4th bed - Cover part with text

0.4 nozzle / 0.24 layer / 2 walls / 15% infill / wall generator Arachne

here you can edit your own text on the cover part.

Assembly instructions in the manual. But you can do it without it ;). 

First attach the base to the wall. Screws/nails must be embedded! Then connect the Cover through the pins, you can use glue - it's better.

The colors of the model are up to you. The same goes for the material. I would recommend keychains = owls made of PETG.