This is a 3D-printed figure of a cool, anthropomorphic banana, posed with one hand on its hip and the other giving a thumbs-up. The figure wears stylish sunglasses and has a wide smile, with its peel peeled back to reveal the "body." The surface has a realistic texture and brown spots, giving it a playful, ripe banana look.

3D Printing Technical Sheet: The Cool Banana

• 3D Model: The "Cool Banana Dude"
• Designer: Fan art creator from a popular online repository (e.g., Thingiverse)
• Dimensions: Approximately 180 mm (height) x 100 mm (width) x 100 mm (depth)
• Weight of Object: Approx. 120 grams

Printing Parameters and Post-processing

• Slicing Software: Ultimaker Cura v5.6.0
• Printer: Fused Deposition Modeling (FDM) Printer (e.g., Prusa MK4)
• Filament:
  • Type: PLA+
  • Base Colors: Matte Yellow for the banana, Black for the base.
• FDM Printing Configuration:
  • Layer Height: 0.12 mm (for a smooth surface with minimal visible lines)
  • Infill Density: 10%
  • Infill Pattern: Gyroid (for good structural integrity with low weight)
  • Support Strategy: Tree supports enabled only for the thumbs-up hand and the underside of the peeled sections.
  • Adhesion: Skirt with a 5 mm offset.
• Estimated Print Time: 7 hours, 30 minutes
• Post-processing & Finishing:
  • Support Removal: Supports were carefully removed from the thumb and peel.
  • Sanding: Light sanding with fine-grit sandpaper (400-600 grit) to remove layer lines and support marks.
  • Painting: The brown spots were painted on with a thin brush and acrylic paint after the initial print, giving it the ripe look. The sunglasses are likely a separate print, painted silver/black, and then glued in place, or the main figure was painted in post-processing.
  • Protective Coat: A matte or semi-gloss clear coat applied to the entire figure to protect the paint and give a uniform finish.