Nexprint Logo
Beta
3D ModelsEvents1 Million Creator Fund
$
2
4
6
6
9
Upload

  • Blumat

  • Wattering

  • ring

  • drip

Blumat Ring 150
Print Profile(0)

  • Earn points by adding print configurations

1

2

22

1

Released 2025-10-07
Details
Files(1)
Makes & Comments (0)

This ring allows for even distribution of water around the trunk with Blumat irrigation systems. Once assembled, you will need to perforate the 8mm pipe. I recommend using a heated needle or a 1mm (or 0.5mm) drill bit to make one to three holes in each sector of the tubing. Remember, the smaller the holes, the most you can make. 

Bill of materials

  • Name
    Quantity
    Notes
  • 1
    8mm Ø Blumat feeding tube
    1
  • 2
    Blumat 3-8 mm End Piece
    1
  • 3
    Tropf Blumat
    1
    Normal or maxi models are suitable

Originality of the Model

The author declares that this work is their personally original model

This model is licensed under the following terms:

Credit must be given to the creator

Only noncommercial uses of the work are permitted

Remixes must be shared under the same license

Models(1)

  • model file image
    Bluelab Ring 150 v1.4.stlDesigner

    267.95 KB

    2025-10-04

No more