PrintABlok are interlocking building toys created by the 3D Printing Professor, designed to work well on home 3D Printers. PrintABloks can be built in all 6 directions, allowing for gravity defying building unlike any other building block out there.

Bloks in this set are designed to twist, roll, and move. Incorporate them into your PrintABlok sets to make dynamic builds.

If you are interested in getting a greater variety of blocks, including articulated blocks and decorative elements to make cool builds, you can check out premium sets here:

http://printablok.com

Recommended Print Settings

While printabloks are design and will print will with any material and most common settings, for best results the following is recommended:

• Layer height 0.16 or lower
  Print connectors in PetG
  And that's it. Enjoy.