Cigarette box (80) with frame

Basic box, you can find skins for it below.

Can be printed without support.

No other parts are needed.

The top of the Cigarette box needs to be cut off and then it can be inserted into the box, no need to repack one by one.

It is a bit difficult to put together, you have to make sure it is in the open position and one side must be fully inserted first. Then carefully push the top out a little and insert the second axle.

0.4 nozzle with basic settings, with a 3mm skirt around for better adhesion, but this can be left out.

I printed with PLA.

There is a rim on the edges, so you can easily position the different skins for it: