Description:

A picture of Diabolik and Eva Kant created using Hueforge software, at the request of a friend who is a fan of the two characters.

Printing Instructions:

No support is required (although Bambu Studio can advise if one is needed); I activated the brim ears for the corners to increase the picture's adhesion. If the print profile is not set correctly or you prefer to set it manually, below are the instructions provided by the Hueforge software:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mm

The Model is 141.33x200mm in size 
You may print at higher layer heights below the Min Depth of 0.48mm 
The Max Depth is 3.3mm and the Actual Depth is 3.1mm

Filaments Used: 
PLA PolyLite Black Transmission Distance: 0.3 
PLA BambuLab Basic Red Transmission Distance: 4 
PLA PolyLite Gray Transmission Distance: 1 
PLA PolyLite White Transmission Distance: 5 
This print uses 4 unique filaments

Swap Instructions: 
Start with Black 
At layer #8 (0.72mm) swap to Red 
At layer Swap layer #15 (1.28mm) to Grey.

Swap layer #25 (2.08mm) to White for the remainder.

Assembly Instructions:

No assembly required, as the model is made in one piece.

Post-Processing:

Some stringing may appear on the surface; a quick blow-dry with a hairdryer or lighter should remove it.