Z Stop Endstop Spacer for fast Bed to Glass transition for Creality Ender 3
Print Profile(0)
5
1
Released 2025-07-24
Z stop spacer to transition from Bed to 3.2mm (1/8") thick glass or mirror without adjusting the level. Slide to the right away from Z stop switch when printing on bed.
Add tape or lightly sand to fine tune as needed. Make sure it is fully seated when using.
This is 3.4mm thick on the bottom which gave me perfect first layer results without re-leveling the bed.
2.5mm hole can be tapped for 3mm screw if needed. Or you can add some tape inside to make it fit more tightly. The current design fits my printer perfectly.
Originality of the Model
The author declares that this work is their personally shared model
Original creator:
cafox
Reprint source:https://www.thingiverse.com/thing:2959614
This model is licensed under the following terms:
Credit must be given to the creator
Models(1)
GlassSpacerV1.stl
98.06 KB
2025-07-18
No more
