handle
door
mod
stop
stopper
clogged
doorstop
anycubic
kobra
kobras1
kobras1c
s1c
s1
kobras1combo
s1combo
doorholder
holder
unclog
unclegger
unclogged
- 0.2mm layer, 2 walls, 20% infill
1-disc
PLA
Designer
32
6
This design will help you avoid clogs in your hotend during printing with PLA and PETG by keeping the chamber of your printer well-ventilated.
Assembly instructions
1. Remove screw of original handle
2. Reassemble the handle + door holder. Use the same screws
Instructions for use
The door holder must be locked in each position, closed or open, to do this you only need to push up to unlock, turn and push down again to lock
Originality of the Model
The author declares that this work is their personally original model
This model is licensed under the following terms:
Credit must be given to the creator
Only noncommercial uses of the work are permitted
Models(1)
- door_holder_S1_bs.3mfDesigner
323.70 KB
2025-06-18
