3D printable rear panel for the Voron V0 with an 80mm fan mount. This remixed design uses nuts instead of heat set inserts to hold the fan in place. This allows the panel to be printed in any orientation (i.e. textured side on the inside or the outside). It also adds a mesh over the ventilation holes to match the meshed skirts.

This is a multibody part so make sure you set the mesh to 0 top and bottom layers so it comes out as mesh like pictures. There are guides on how to do this. i used a 5v 80mm fan plugged into the the BTT Pi onboard fan port, but you can use 24v fan plugged into the BTT Pico as well.