formd t1
FORMD
FormD T1 2.75 and 3 Slot PSU Support
Print Profile(1)
T1 PSU Support - PLA
1-disc
PLA
Designer
12
1
Released 2025-05-16
PSU support for the Formd T1 v2.0 in 2.75 or 3 slot mode, does not require any additional hardware. Helps support the PSU and keep the screw from scratching the finish. Versions v2.1 and higher have a revised front panel that make this mode not necessary.
Note in the picture I used a long screw which is why it sticks out, a short screw can also be used (as long as is is counter sunk).
Originality of the Model
The author declares that this work is their personally remixed model
Original creator:
gordeh
Adaptation source:https://www.thingiverse.com/thing:5468828
This model is licensed under the following terms:
Credit must be given to the creator
Only noncommercial uses of the work are permitted
Remixes must be shared under the same license
Models(3)
formdt1_3slot_psu_support.stlDesigner
9.36 KB
2025-05-16
- formdt1_2_75_slot_psu_support.stlDesigner
14.34 KB
2025-05-16
- PSU_Support.3mfDesigner
39.17 KB
2025-05-16
View all(3)
No more
