You’ll need glue and five 5×2 mm magnets

On layer 18 of the handle (spoon), a pause was set for about 26 minutes. At this point, attach two magnets to the handle, making sure their poles are aligned.

No supports are required for the handle—ignore any prompts—and the 18-mm bridge is negligible.

It may feel a bit stiff at first, but with a few uses it will become smoother; you might need to apply a little extra force.

Next comes the installation step—make sure not to reverse the magnets 😄

The installation method for the pudding version is roughly the same.

When attaching these magnets, it’s best to first place a piece of tape on the base surface—it helps with adhesion and eliminates the need to peel it off later. Ensure the magnetic poles remain consistent (since we’re aiming for a thinner design, the connection is continuous).

Once attached

Insert the handle diagonally along the diagonal line, then gently lay it flat. Make sure the magnet on the handle attracts the magnet on the base; if they repel, adjust the orientation slightly before reinserting.

Insert two locating pins, preferably coated with glue.

Finally, attach one more magnet to the small base, and you’re all done!!