The design and color scheme of the original movie artwork have been faithfully reproduced as much as possible.

You can heat the back of the lighter and then gently bend it with heat to make it fit more easily against the shelf and adhere better.

With 100% infill, the layer height is 0.08 mm, and the first-layer height is 0.16 mm.

The model dimensions are 90 x 39.87 mm.
You can print at a higher layer height than the base thickness by 0.48 mm,
with a maximum allowable thickness of 3.92 mm and an actual thickness of 3.68 mm.

Instructions for changing filament materials (it is recommended to use translucent PETG):

    Start with black
    At layer #20 (1.68 mm), switch to dark blue
    At layer #27 (2.24 mm), switch to San Ci semi-transparent blue-white (ice blue)
    At layer #33 (2.72 mm), switch to white and continue until the end.