1:64 Rotating 3D Parking Garage

Supports Cyberbrick remote control with electric drive and lighting or manual dual-mode operation   

Supports up to 10 cars parked simultaneously   

Overall dimensions: 270 mm (height) × 160 mm (width) × 180 mm (maximum depth, 165 mm at the base)

Maximum car dimensions supported: 78 mm × 36 mm × 31.5 mm

The structural parts are printed in PETG, with a small portion of the exterior finished in PLA and minimal support material used.

The chain and car platform require some assembly time, while the remaining components are straightforward to put together; please refer to the attached documentation for details.

--------------------------------------------------------------------------------------------------------

Additional screws required: M2×6, 80 pieces; M2.5×10, 42 pieces; M3×12 flat-head, 3 pieces; 608 bearings, 4 pieces.

Cyberbrick: 2 lithium batteries, 2 switches, 1 receiver module, 1 transmitter module, 1 single-channel joystick, 1 030 motor (requires a 1:48 reduction gearbox to be 3D-printed), 1 LED light board, 1 LED bead, and 17 M2.5×6 screws.

All contact parts, including gears, chains, and cross shafts, are recommended to be lightly lubricated with grease.

--------------------------------------------------------------------------------------------------------

For those who only need manual operation and do not require Cyberbrick remote control or lighting, the parts circled in red below can be removed.

For those who want electric operation but don’t have Cyberbrick, I’ve uploaded the STP file for the “distribution box and cover,” which you can modify yourself to fit PWM-compatible dimensions or simply connect externally. However, please be sure to reduce the speed—too fast and it’ll turn into a runaway vehicle.